5.0mm Cable Fast Connector

As a professional manufacturer from China, Yuanyi would like to provide you 5.0mm Fiber Optic Fast Connector is engineered for FTTH access networks and outdoor fiber optic installations that require efficient on-site termination. The connector adopts a pre-polished ferrule and optimized internal alignment structure to simplify the termination process while maintaining consistent optical connection performance.

Key Features

Physical Specifications

Optical Performance

Mechanical & Environmental Data

Pairing with Waterproof Pre-connectorized Products

Note: This combination allows installers to keep waterproof protection at factory-sealed sections while using the 5.0mm cable Fast Connector (also an excellent FTTH Quick Connector) for final indoor/field termination.

Installation Instructions

Strip – Remove 5.0mm outer jacket and aramid yarn.

Clean & Cleave – Clean bare fiber and cleave precisely (8–12mm length).

Insert – Insert 5.0mm cable into the connector body until fiber reaches stop point.

Clamp – Close cover and tighten strain relief boot.

Test – Verify IL with power meter or OTDR.

Packaging

Applications

The 5.0mm Fiber Optic Fast Connector is suitable for fiber access and maintenance applications where compatible 5.0mm round drop cable is used.

FTTH Last-Mile Networks

Used for rapid termination of drop cables in residential and commercial FTTH access networks, particularly where installation speed is important.

Outdoor Fiber Termination

Suitable for outdoor distribution points, fiber termination boxes, and other access network locations requiring field-installed optical connectors.

Aerial and Underground Fiber Deployment

Can be used at transition points between aerial, duct, and buried fiber routes where field termination is required.

Network Repair and Maintenance

Provides a practical option for replacement and repair work when a damaged or newly installed drop cable needs to be terminated on site.

Hybrid Waterproof Fiber Deployment

The connector can be used together with compatible IP68 pre-connectorized fiber optic products, allowing factory-sealed waterproof sections to be combined with field-installed termination points.

FAQ

What cable is compatible with this 5.0mm fast connector?

The connector is designed for 5.0mm round single-fiber drop cables with a nominal outer diameter of 5.0mm ±0.1mm. Cable construction and fiber type should be confirmed before ordering.

Is this connector suitable for FTTH installation?

Yes. The connector is designed for FTTH last-mile access applications, including field termination of compatible 5.0mm drop cables.

Does the connector require epoxy or polishing?

The fast connector uses a pre-polished ferrule and is designed to avoid conventional field epoxy curing and manual connector polishing during normal installation.

What fiber type does it support?

The listed specification is for single-mode 9/125μm fiber, with an operating wavelength range of 1310–1650 nm.

Can it be used with waterproof pre-connectorized fiber products?

Yes. It is designed to work with compatible waterproof pre-connectorized products, including IP68 assemblies, for hybrid FTTH deployment.